C60离子束撞击固体表面的坍塌与沉积(II)扫描隧道显微研究

Mass-selected C60 beam produced by laser ablation was accelerated and bombarded the (0001) surface of highly oriented pyrolitic graphite and (111) surface of gold single crystal. The samples were characterized by STM. The STM images showed that, the deposited species collapsed and formed planar structure on the solid surface, but the collapsed species were not dissociated and well oriented on the surface. Both positive and negative C60 ions were observed in the desorption mass spectra, confirming that the species collapsed on the solid surface are still the C60 clusters.     

Electrospray ionization/atmospheric pressure photoionization multimode source for low-flow liquid chromatography/mass spectrometric analysis

Analysis of several polar and non-polar compounds is performed with a newly developed dual electrospray ionization/atmospheric pressure photoionization (ESI/APPI) or ESPI source. Several variables are considered in the source, such as ESI probe heater temperature, solvent flow, dopant effects, repeller plate voltage, source geometry and photon energy (Kr vs. Ar lamp). Direct photoionization resulting in a molecular radical cation [M](*+) dominates at high temperatures (>400 degrees C) and low flow rates (<200 microL/min). Indirect photo-induced chemical ionization (PCI) involving solvent molecules becomes important at lower temperatures and higher solvent flow rates. Indirect PCI is enhanced using an Ar lamp, which yields comparable [M+H](+) signal but poorer [M](*+) signal than the Kr lamp at lower temperatures and higher flow rates. This is in support of our recent finding that the Ar lamp results in a solvent-dependent enhancement of analyte molecules via PCI. Analysis of 12 compounds in methanol under low-flow conditions (10 microL/min) demonstrates that the dual ESPI source performs favorably for most compounds versus the standard ESCI source, and significantly better than ESCI for the analysis of unstable drugs, like flurbiprofen. Several factors contributing to the benefits of the ESPI source are the shared optimal geometry for ESI and APPI sources and soft ionization of APPI versus APCI.     

Poly (3-(3-pyridyl) acrylic acid) modified glassy carbon electrode for simultaneous determination of dopamine, ascorbic acid and uric acid

Trans-3-(3-pyridyl) acrylic acid (PAA) was deposited on glassy carbon electrode (GCE) by electropolymerization in pH 7.0 phosphate buffer solution (PBS). The poly (3-(3-pyridyl) acrylic acid) (PPAA) film modified glassy carbon electrode shows an excellent electrochemical response for dopamine (DA), ascorbic acid (AA) and uric acid (UA). The cyclic voltammetry oxidation peaks for DA and AA, DA and UA, AA and UA are separated by 150 mV, 130 mV and 280 mV, respectively. This permits the simultaneous determination of AA, DA and UA. The interference of AA with the determination of DA could be eliminated because of the electrostatic interaction between DA cations and the negatively charged PPAA film at pH 7.0. The anodic peak currents of DA, AA and UA increase linearly with concentration in the range of 1-40 micromol L(-1), 10-400 micromol L(-1) and 1.6-80 micromol L(-1), respectively, with a correlation coefficient (r) always higher than 0.998. The detection limit is 0.06 micromol L(-1), 0.8 micromol L(-1) and 1.1 micromol L(-1) for DA, AA and UA, respectively.     

Stannous oxalate as a novel catalyst for the synthesis of polytrimethylene terephthalate

Stannous oxalate was prepared efficiently and characterized by XRD and FT-IR. It exhibited higher catalytic activity and had profitable effect than tetrabutyl titanate and stannous octoate for the synthesis of polytrimethylene terephthalate (PTT) via esterification-route. Over this catalyst, the degree of esterification of pure terephthalic acid was up to 94.4% at 260°C after 1.5 h, while the intrinsic viscosity and content of terminal carboxyl groups of the corresponding PTT polyester, polymerized at 260°C, 60 Pa for 2 h, was 0.8950 dL/g and 15 mol/t, respectively. Stannous oxalate was a promising catalyst for the synthesis of PTT polyester.     

CO2选择性氧化甲烷制C2烃催化剂La2O3/ZnO的氧化还原和CO2吸附性能

Ｌａ２Ｏ３／ＺｎＯ催化剂体系在以二氧化碳作为氧化剂的甲烷氧化偶联反应中具有很高的Ｃ２烃选择性和稳定性．采用ＣＯ２－ＴＰＤ－ＭＳ和ＴＰＲ技术考察了Ｌａ２Ｏ３／ＺｎＯ对ＣＯ２的吸附性质及其氧化还原行为．结果表明：（１）Ｌａ２Ｏ３／ＺｎＯ催化剂体系存在着强、弱两种碱中心，其中弱碱中心数量随样品中Ｌａ２Ｏ３含量增加而减少，强碱中心强度随样品中Ｌａ２Ｏ３含量增加而增强．（２）由于组分相互作用，高温下，Ｌａ２Ｏ３／ＺｎＯ易产生晶格氧空位，使之对ＣＯ２的吸附增强，吸附后的ＣＯ２与晶格氧作用形成立方晶型Ｌａ２Ｏ２ＣＯ３．（３）Ｌａ２Ｏ３／ＺｎＯ表面的Ｌａ３＋和Ｚｎ２＋可以部分被还原，由于组分间的相互作用，使得二者的还原都较单一组分存在时更难．（４）Ｈ２－ＣＯ２－Ｈ２氧化还原循环实验表明，Ｌａ２Ｏ３／ＺｎＯ表面被部分还原后，ＣＯ２可以将部分被还原的表面再氧化．在此基础上对Ｌａ２Ｏ３／ＺｎＯ催化剂上甲烷与ＣＯ２转化为Ｃ２烃的机制也进行了讨论．     

Direct amino acid analysis method for speciation of selenoamino acids using high-performance anion-exchange chromatography coupled with integrated pulsed amperometric detection

Speciation analysis of selenomethylcysteine (SeMeCys), selenomethionine (SeMet) and selenocystine (SeCys) has been performed using a direct amino acid analysis method with high-performance anion-exchange chromatography (HPAEC) coupled with integrated pulsed amperometric detection (IPAD). Three selenoamino acids could be baseline-separated from 19 amino acids using gradient elution conditions for amino acids and determined under new six-potential waveform. Detection limits for SeMeCys, SeMet and SeCys were 0.25, 1 and 20 microg/L (25 microL injection, 10 times of the baseline noise), respectively. The relative standard deviations (RSDs) of 200 microg/L SeMeCys, SeMet and SeCys were 3.1, 4.1 and 2.8%, respectively (n=9, 25 microL injection). The proposed method has been applied for determination of selenoamino acids in extracts of garlic and selenious yeast granule samples. No selenoamino acids were found in garlic. Both SeMet and SeCys were detected in selenious yeast tablet with the content of 45 and 129 microg Se/g, respectively. Selenoamino acids standards were spiked in garlic and yeast granule samples and the recovery ranged from 90 to 106%.     

Evaluation of an on-line coupled continuous flow liquid membrane extraction and precolumn system as trace enrichment technique by liquid chromatographic determination of bisphenol A

An on-line coupled continuous flow liquid membrane extraction (CFLME) and C₁₈ precolumn system was developed for sample preconcentration in liquid chromatography determination. After preconcentration by CFLME, which is based on the combination of continuous flow liquid–liquid extraction and supported liquid membrane, bisphenol A (BPA) was enriched in 960 μl of 1 mol l⁻¹ NaOH used as acceptor. This acceptor was on-line neutralized and transported onto the C₁₈ precolumn where analytes were absorbed and focused. Then the focused analytes were injected onto a C₁₈ analytical column for separation and detected at 220 nm with a diode array detector. CFLME related parameters such as flow rates, pH of donor and acceptor, and enrichment time were optimized. The proposed method presents a detection limit of 0.03 μg l⁻¹ (S/N=3) when 60 ml samples was enriched with an enrichment time of 30 min. Compared with C₁₈ based column-switching procedure, this proposed procedure presents similar sample throughput and lower detection limits. The proposed method was successfully applied to determine BPA in tap water, river water, and municipal sewage effluent samples.     

Synthesis and characterization of ionic organotin compounds [R2SnCl2(2-quin)](HNEt3) and crystal structures of [(2,4-Cl2-C6H3CH2)2SnCl2(2-quin)](HNEt3)

Eight ionic organotin compounds [R₂SnCl₂(2-quin)]⁻(HNEt₃)⁺ have been synthesized by reactions of 2-quinH with R₂SnCl₂ (R = PhCH₂1, 2-Cl-C₆H₄CH₂2, 4-Cl-C₆H₄CH₂3, 2-F-C₆H₄CH₂4, 4-F-C₆H₄CH₂5, 4-CN-C₆H₄CH₂6, Ph 7, 2,4-Cl₂-C₆H₃CH₂8) in the presence of organic base NEt₃, and their structures have been characterized by elemental analysis, IR and multinuclear NMR (¹H, ¹³C, ¹¹⁹Sn) spectroscopies. The structure of [(2,4-Cl₂-C₆H₃CH₂)₂SnCl₂(2-quin)]⁻(NEt₃)⁺ (8) has been determined by X-ray diffraction study. Studies show that compound 8 has a monomeric structure with the central tin atom six-coordinate in a distorted octahedral configuration and the nitrogen atoms of the 2-quin ligands are coordinating to the tin atom in all the eight compounds.     

Ab initio study of low-lying electronic states of the FNO2 molecule

Ab initio electronic structure calculations are reported for low-lying electronic states, ¹A₁, ¹A₂, ³A₂, ¹B₁, ³B₁, ¹B₂, and ³B₂ of the FNO₂ molecule. Geometric parameters for the ground state ¹A₁ are predicted by MRSDCI calculations with a double-zeta plus polarization basis set. The vertical excitation energies for these electronic states are determined using MRSDCI/DZ+P calculations at the ground-state equilibrium conformation. The oscillator strengths and radiative lifetimes for some electronic states are calculated based on the MRSDCI wave functions. © 1993 John Wiley & Sons, Inc.     

Evaluation of the retention dependence on the physicochemical properties of solutes in reversed-phase liquid chromatographic linear gradient elution based on linear solvation energy relationships

This paper describes the results of the evaluation of retention dependence on the physicochemical properties of solutes in linear gradient elution by reversed-phase liquid chromatography (RPLC) based on linear solvation energy relationships (LSERs). Retention time data on Inertsil ODS(3) column by linear gradient elution were collected for both acetonitrile-water and methanol-water binary mobile phases under various gradient steepness. Based on the LSERs, the retention times were linearly correlated with the physicochemical properties (size, dipolarity, and hydrogen bond donor-acceptor acidity and basicity) of solutes. As predicted by LSERs, very acceptable linear relationships are observed for both mobile phases. While the magnitudes of the coefficients are modified by the gradient steepness, their signs are consistent with those obtained by isocratic elution. As obtained for isocratic elution, the dominant factors to retention in linear gradient elution of RPLC are the solutes' size and hydrogen bond acceptor basicity. The conclusions of the study allow us to predict retention in chromatographic method development by gradient elution.